MX1508 motor driver

The MX1508 motor driver module is a small, low-cost module used to control DC motors and small stepper motors. It is based on the MX1508 IC, which allows for bidirectional control of two DC motors or a single stepper motor. This module is commonly used in small robotics projects, Arduino projects, and other DIY electronics projects.

For full project:

https://electronicsworkshops.com/2024/07/31/mx1508-motor-driver-module/

Key Features:

Dual H-Bridge Motor Driver: The MX1508 can drive two DC motors simultaneously, or one stepper motor, in both directions (forward and reverse).

Voltage Range: The module operates within a wide voltage range, typically from 2V to 10V.

Current Capacity: Each channel can handle up to 1.5A of current.

Compact Size: The module is small, making it suitable for projects with limited space.

PWM Control: It supports PWM (Pulse Width Modulation) control, allowing for speed regulation of the motors.

Pinout:

VCC: Power supply input for the motor driver, usually 2V to 10V.

GND: Ground connection.

INA, INB: Control pins for Motor A (DC Motor 1).

INC, IND: Control pins for Motor B (DC Motor 2).

OUT1, OUT2: Motor A outputs (connect to the terminals of Motor A).

OUT3, OUT4: Motor B outputs (connect to the terminals of Motor B).

For full project:

https://electronicsworkshops.com/2024/07/31/mx1508-motor-driver-module/