How can we help?

Remark for drills is not fitted with the actual drill table in file

Reason of failed review:

Please find the attached pic. The drill table you remarked in your file is not fitted with drill file. Can we just ignore the difference and proceed with the drill file?

Suggestion:

Please kindly check your drill file and the drill table remarked in your file. Otherwise, it might be confusing for us to check.

Last updated on 12/03/2024

If you have any question with ordering, feel free to contact us.

Was this article helpful? Yes No

If you cannot find solutions to your problem here please tell us through Facebook or Twitter.

Slots standard size - Limited to Quick-turn PCB
Vias process of design is different from order details option
Some drills overlap the slots at GM or GKO
Requirement about castellated holes
The holes is in the trace and it will cause open circuit
Line/Shapes in GM layer
Drills hurt the circuit
The holes design standard
pls confirm whether solid rectangle area should be made as slot or not
all the holes are with the same size
The castellated holes are partial set in outline instead of in the center for common designs
stamp holes standard
min non-plated holes
the hole limitation for single-side Aluminum boards
Do you need round holes or slots holes made?
drills are not matched with pads
NPTH design rule
How to design cutout or big hole
Remark on rectangle slot

Comments (0)

This message here is only a suggestion supplement to the above content, and does not for trading operations such as orders. If you have any urgent questions or order issues, please contact your sales rep.

Upload photo

You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP

0 / 10000

How can we help?

Remark for drills is not fitted with the actual drill table in file

If you have any question with ordering, feel free to contact us.

How can we improve this article?

Related articles