How can we help?

Line/Shapes in GM layer

Reason of failed review:

The slot requires to be in one separate outline layer.

Suggestion:

1.You can add some remarks in other special request to make it clearer for us to check. Eg: GKO/GM1 layer shows the slots.

2.You can rename this layer as “slot” or other name for clarification.

Last updated on 12/03/2024

If you have any question with ordering, feel free to contact us.

Was this article helpful? Yes No

If you cannot find solutions to your problem here please tell us through Facebook or Twitter.

Slot in oval pads
Remark on rectangle slot
How to design cutout or big hole
NPTH design rule
drills are not matched with pads
Do you need round holes or slots holes made?
the hole limitation for single-side Aluminum boards
min non-plated holes
stamp holes standard
The castellated holes are partial set in outline instead of in the center for common designs
all the holes are with the same size
pls confirm whether solid rectangle area should be made as slot or not
The holes design standard
Remark for drills is not fitted with the actual drill table in file
Drills hurt the circuit
The holes is in the trace and it will cause open circuit
Requirement about castellated holes
Some drills overlap the slots at GM or GKO
Vias process of design is different from order details option

Comments (0)

This message here is only a suggestion supplement to the above content, and does not for trading operations such as orders. If you have any urgent questions or order issues, please contact your sales rep.

Upload photo

You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP

0 / 10000

How can we help?

Line/Shapes in GM layer

If you have any question with ordering, feel free to contact us.

How can we improve this article?

Related articles