How can we help?

V-scoring line/Slot in silkscreen layer

Reason of failed review:

The v-scoring line/slot requires to be in one separate outline layer rather than on copper/silkscreen/soldermask layer. Otherwise, they might be regarded as copper/silkscreen/soldermask and will not be made out as v-scoring line or slot.

Suggestion:

Please design the v-scoring line/slot in one separate outline layer.

If you have any question with ordering, feel free to contact us.

Was this article helpful? Yes No

If you cannot find solutions to your problem here please tell us through Facebook or Twitter.

The parameters in gerber files are different from the order details online.
Some Issues concerning BGA(Ball Grid Array)
Design has no silkscreen layer but online is yes with silkscreen
The are some pads out of the board outline
UL Marking
No Gold fingers design in file
BGA pad opening
Spiral coil board
the spacing requirement from slot to copper trace
Edge plating
the spacing requirement from hole to the edge of board
The spacing from one hole to another is too narrow
The requirement of beveling on gold finger area
the spacing from hole to trace
limited holes spacing
the bottom silkscreen is mirrored
notes in the order are different from the designs in the files
do not design texts on the copper layer
Silkscreen standard size
silkscreen size and spacing in solder mask layer

Comments (0)

This message here is only a suggestion supplement to the above content, and does not for trading operations such as orders. If you have any urgent questions or order issues, please contact your sales rep.

Upload a photo: You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP

0 / 10000

How can we help?

V-scoring line/Slot in silkscreen layer

If you have any question with ordering, feel free to contact us.

How can we improve this article?

Related articles