PCB Prototype the Easy Way

Full feature custom PCB prototype service.

The requirement of beveling on gold finger area

Reason of failed review:

The width of board is less than 45mm. We cannot make beveling in this case.

 

Suggestion:

  If your design include gold finger and need to do beveling, pls pay attention to  below requirements.

1. The length of gold finger area should be  30mm

2. The thickness of board should be  1.2mm

3. The spacing from gold finger to the edge of board should be  1mm

4. Pls design solder mask opening for whole gold finger area, we will not make solder mask bridge.

5.When gold finger needs to be bevelled , the width of board should be more than 45mm. Otherwise, we cannot do the beveling properly. See pic below, the vertical size is less than 45mm , we cannot make beveling by ordinary production line.

pcbway34.png


Related articles

Comments (0)
Note: This message is only for the daily communication between PCBWay and customers. The response is not very timely.
If you have any urgent questions, please contact your salesman!
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP