The question for pin pitch

Question: The pitch for the header can not match to the board hole design.

Answer: Suggest to select corresponding pitch for headers according to the through hole pads distance(such as 2mm, 2.54mm and etc)

图片6.png

The question of component dimension is bigger than the land pattern in the design.
The question of component dimension don’t match the pads on the boards.
The question of the component gap don’t match the boards thickness
The question of component lead pin height don’t match the boards thickness
The question of component lead pin don’t match pads quantity in the design
The question of tooling pin/tooling hole
The question of pin header don’t match the holes on the boards
The question of Sink Type Micro USB
Special requests for PCB and assembly making
The question for holes on pads
Design issue caused poor soldering
Inconformity for component pin distance and the hole space
Inconformity of solder joints and pads on board
The question for missing soldermask opening
The question for LED package
The question of positioning pin
The question of silkscreen marking cannot match with the component
The question of component package
The question of FPCB stiffener for THT pad
How to avoid the problem that LED do not light after receiving soldered PCBs?

Comments (0)

Note: This message is only for the daily communication between PCBWay and customers. The response is not very timely.
If you have any urgent questions, please contact your salesman!

Upload a photo: You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP

Back

The question for pin pitch

Related articles

My Orders

My Account

Balance & Coupons

Delivery

Service & Refunds

Payments

Technical Support

Design for PCB Manufacturing

PCB Assembly FAQ

Self Service