PCB Prototype the Easy Way

Full feature custom PCB prototype service.

The question of component dimension is bigger than the land pattern in the design.

There are some constantly assembly questions when the factory verify the component with the boards after the boards and component arrived completely.

Q:SMD Component dimension is bigger than the land pattern in the design, blocked the nearby pads on the boards,cant be soldered.

A: Please refer the data-sheet of component dimension and recommended PCB layout re-design and re-manufacture the boards or provide alternative MPN.

For some big dimension component please keep enough land pattern gap with nearby pads to prevent conflict.

components.png

Q: Through hole components conflicted with nearby components.

A: Soldered the SMD components firstly,and soldered through hole component float on the boards.

components2.png


Comments (0)
Note: This message is only for the daily communication between PCBWay and customers. The response is not very timely.
If you have any urgent questions, please contact your salesman!
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP