This is the original COREi64 Ultimate 64 Userport installation kit for the Commodore 64c.

With Gideon's recent release of the Ultimate64 FPGA computer main board, it became quickly apparent that a set of 3D printed parts were needed to complete a quality installation of the userport board in a 64c Commodore case. This part set is compatible with both the regular and Elite versions of the Ultimate 64.

The components that comprise the complete kit includes the internal mount and cap. Both pieces need to be ordered to complete the install kit.

This is a brief description of each item in the kit:

Internal userport mount (two M2 heatsets are required)

Internal userport mount cap

This installation set of parts is compatible with the Gideon Ultimate64 standard and elite mainboards, and is compatible with the 64c, kickstarter and post-kickstarter cases.

Required heatsets and screws are as follows (and the responsibility of the purchaser to order and install).

Heat sets (M2 - 2 are required)

https://www.mcmaster.com/catalog/94180A307

Screw (2 M2/6 required for keyboard brackets)

https://www.mcmaster.com/91290A013

Note: Heatsets should be melted into the keyboard brackets only if you're having these manufactured in ABS or PLA. If you're resin printing these brackets, then you should superglue the heatsets into the holes in the top of the keyboard brackets. You may need to drill out the heatset holes a little so the heatsets will be snug when inserted. The superglue will hold them in place. Ensure you don't get any superglue on the thread.

Licence Notes: You may feel free to order these brackets and sell them anywhere you'd like. They need not be only purchased for personal use. Commercial use is permitted. Attribution must be added to your for sale listings should you decided to sell these commercially.