hi, I need to design a rigid flex pcb. It's a 2 layer design and i don't how to set up the layer stack up in Kicad. Then is it ok just to use different design layers to point out the flex part and the...
hello, i want to buy from the store and pay with cash, not using beans. is it still possible? how can i do it? the cash option does not appear any more in the page i view. thank you in advance.
Hello.We need to design a PCB board in FR4 (1.6mm thickness) and create areas with Z-milling (https://www.pcbway.com/blog/Engineering_Technical/Milling_of_PCB.html). How can we define them so you mill...
I would like to know if it is possible to make PCBs with z-axis milling, and if it is possible, how to specify areas. In the attached example, see that we need to make a pcb similar to a "frame" and t...
Hello,I am looking to design a flex PCB using embedded resistors of 25-50 ohms each. I was wondering how this is done within the EDA. What layer do I use to layout these embedded resistors if its poss...
Hi Agnieszka!I wanted to build the USB-Joy adapter and looking for the source code or firmware for the ATSAMD21? Is there any project site or similiar with the needed information?Thanks!
Hi, I'm working on a rigid-flex design, 8-layer board, with flex on layers 4 and 5, and drill structure (except of regular through holes):uvias 1-2, 0.1mm hole,uvias 2-3, 0.1mm hole,buried vias 3-6, 0...
Hello! I need to extend a Hirose 40pin connection and need advice on the best way to do this.I think the way forward is likely to design a interconnection PCB board that uses an FFC as an intermediate...
Hello.I am looking for a pcb fo Hi-Link HLK-PMxx modules.Something like:https://sklep.avt.pl/pl/products/adapter-zasilacza-do-modulu-hlk-pmxx-pcb-do-projektu-avt-5785-185214.htmlDo you know anything s...
