Hello,i upload a .step file for CNC milling. The original modell .step file is very fine in detailing but in the preview view the modell is very rought (a radius in the stepfile is not round its shows...
It says to use M1.6 + M1 Brass inserts. Is there specific spots where each of them should go into? I’m determining if j need to buy both or just go for one for my build. Also where would you recommend...
Can you provide details regarding the stack up of a 2-layer copper core PCB with the metal base on the bottom. I would like details on how the thermoelectric separation design is manufactured. You pr...
Hi,I need a custom stack-up 6 layer PCB with a final thickness of 1 to 1.6 mm with this stack-up:Cu - 35uPP - 0.1 mmCu - 35uCore - 0.15 mmCu - 35uPP - thickness as requiredCu 35uCore - 0.15 mmCu 35uPP...
In-Ears headphones use magnetic dynamic drivers. If you bring the in-ears close to an electronic device that releases magnetism with a 29" CRT TV (coils, speaker) turned on, will this TV cause demagne...
hi i need somthing like this OpenBCI V3 compatible Open Source EEG Brain Wave Module 8CH Cable Version it is open source, tho if you could i would like it be made for me .GitHub - OpenBCI/V3_Hardware...
Hello, I was about to check out but see the new tarriff rate hasn't been updated for the US. Do you know when that will be updated on your end? Thanks!
Dear Madam/Sir,I would please like, to know if you are able to replicate a plastic part I have, it has to be resistant because it will have a spring attached to it. Thanks in advance.Kind regards,Rod.
