Hi there,I’ve seen there are adaptions of the “Alice” microphone circuit to various PCB formats – really great work!I’m wondering: would it be possible to fit the Alice circuit onto a very compact PCB...
Trying to build the emergency light. Could you please give me the value for the trim pot you used and the zenner diode. and also the component list says 5R 2W for the 2 watt resistor however the mark...
Hello,We need a quick turnaround for about 10 boards with one small DSBGA-16 Package (1.5mm × 1.5mm). To be able to route it, the minimum trace width/gap should go down to 3/2.5mil or 2.7/2.65mil.Ther...
Anyone have any ways to handheld a PS2 SLIM, or better parts for updating and upgrading power to a type c usb? Email me please tomo690.af@gmail.com please
I'm having a similar problem. I've built a HOD2Ami v2 based on an STM32F105. I've used 0 ohm resistors for VCAp1 and VCAP2. With PA9 on 2-3, I always get the same message: No USB device recognized: Th...
According to the renders on PCBWay, the FlippyDrive Ethernet adapter and Micro SD card extension mods require the use of brackets for installation on the FlippyDrive compatible Panasonic Q rear shield...
