Hello, I need to make a single-layer IMS PCB due to the high temperature operating temperature of my design.I need to connect some wires or connectors from the bottom side of the IMS PCB.Is this ...
Hi, I ordered FPC from PCBWay which 0.15 mm thickness ( 1/3 oz copper, 2-layer min. track width 0.06mm)I will use this FPC in my senior project, but i need mechanical properties like density, you...
I have the schematics of a device in pdf. I also have the BOM in an excel file. I want to know if pcbway can print and assemble the device, using the schematics from the pdf and the BOM from the excel...
If I upload a design that uses pure DVI protocol (no audio, no HDCP, no logo) over an HDMI connector, are there licensing issues if I share that design with the community? I read that there are ...
Good dayIs it possible to change the gerber files of a shared project?I have a shared project, I have made some few improvement an dwould like to edit it.Is it possible? How?Thanks
All my old pc boards were made using tape and 1 to 1 negative's. All are single sided and relatively uncomplicated.Is there a way for me to convert some of them to a Gerber file so I can use your ...
Is it possible to fill a standard 10 * 10cm module with a board from this project? So that there are 4 such boards on a standard 10 * 10cm module. How to do it and how much will it cost?https://www.pc...
SA a?bim bu 1200w amfinin sende kart? mevcut ise al?c? olmak isteriz ?orumdan ileti?ime giriyorum 05541197683 numaral? tlf mesaj atarsan sevinirim a?bim.
