Hello.Looking for gerber files for Adapter SOT23 SOP10 na DIP10 as in the link belowhttps://elty.pl/pl/p/Adapter-SOT23-SOP10-na-DIP10/1014.could somebody help?Thanks for You help.
I have made project 2 layer PCB for PCB Design Contest,When other User try to order the message error PCB 3 Layer please fill order for L1, L2, L3, L4.This my project:https://www.pcbway.com/project/sh...
Hello,I am desiging a 4-layer RF board with 50 ohm impedence control for RF signals. I need the following information from pcbway before I finish up the layout and submit the order: 1) What...
Because many customers don't know the meaning of vias process on our website or choose them as default. So we always follow the gerber files to produce the vias to avoid mistake. This is our solut...
A basic PCB starts with a copper-clad fiberglass material or thin copper sheets adhered to either side of the board, as shown in Figure 1-5.Figure 1-5. Core material.With a multilayer board (a board...
Hi,I want to have microvias in my design but drilled vias would be 0.3mm, min trace width and clearance 5/5mil. Problem is that during order i have to select HDI in order to have microvia but then it ...
Rep: For no space V-cut, you just need to keep the copper trace with 0-0.5 MM space from the V-cut line.While for V-cut with space, the space need to be larger than 3MM and the min size of break-away ...
Rep:For panel by tab-route, we required 2MM space between single PCB and the connection place need to wider than 1.6MM. As the stamp hole on connection place need to be 0.45MM diameter and 0.35MM spac...
