### DESCRIPTION

Useful to share the 20 pins of an IDC male connector to different ways to get the signals.

The thikness of this board permit to mount (soldering) a 20 pin female on J1.

All these signals are repeated on the correspondant pin number of a Front connector and an identical Back connector.

There is place for a resistor and a LED that will light if on the pin 19 - 20 is applied the supply.

### TECHNICAL DETAILS / COMPONENTS

The width of the trace is abnornally large and can cause danger if there is applied high voltage. The isolation can be not good to install to a plant, but can be useful into a laboratory development.

### LEARN / TOPIC / BUILD INSTRUCTIONS

You need to dismount the female connector for ribbon cable and put the pad of J1 between the two row of "forks" remaining, paying attention to the alignment.