Description
GBA Cart Extender for aPocket
This should allow you to extend your GBA games to be flush with the Analogue Pocket top. Useful for games like Boktai. Untested,
Order as 0.8mm thickness.
You will also need to trim/cut a lot of the GBA reproduction cart and find a way to close the shell, a custom 3d printed shell could be useful.
Dec 17,2021
4,142 views
GBA Cart Extender for aPocket
This should allow you to extend your GBA games to be flush with the Analogue Pocket top. Useful for games like Boktai. Untested
4142
1
1
Published: Dec 17,2021
Standard PCB
PCBWay Donate 10% cost To Author
Only PCB
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Under the
Attribution-ShareAlike (CC BY-SA)
License.
Topic
- Comments(1)
- Likes(1)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
More by AlexiG
-
NDS Y10-01 Replacement PCB
This is a replacement NDS Y10-01 PCB. Useful if you have existing games that have damaged PCBs, simp...
-
Gameboy 32KB Flash Cart
A 32KB Flash cart for the Gameboy. Order as 0.8mm and ENIG surface finish
-
Gameboy Debug Cart
A simple Gameboy debug cart, order as 0.8mm
-
GBA Cart Extender for aPocket
This should allow you to extend your GBA games to be flush with the Analogue Pocket top. Useful for ...
-
GBA Cartridge Slot FFC Extender (End)
Just a simple board which allows you to extend your GBA’s cartridge slot to another PCB by using a 3...
-
GBA Cartridge Slot FFC Extender (Start)
Just a simple board which allows you to extend your GBA’s cartridge slot to another PCB by using a 3...
-
GB 32KB XMAS Flash Cart
A Gameboy 32KB XMAS based flash cart. Uses a binary counter to animate the LEDs depending on the bri...
You may also like
-
-
-
-
Tester for Touch Screen Digitizer without using microcontroller
230 2 2 -
Audio reactive glow LED wristband/bracelet with NFC / RFID-Tags
238 0 1 -
-
-
