Bob Breadboard v1.2 is a PCB prototype board.

The board provides a way to transfer breadboard prototypes to PCB fast and easy.

The board consists of plated-thru holes.

The board length and width is slightly smaller than a 1/2 size breadboard.

The Front of the board contains traces that mimic a 1/2 size breadboard.

These traces can be used, or cut, as required.

At 0.8mm, the board is a little thinner than standard boards, so it can be easily cut into pieces.

You can take 1 board out of a larger group of breadboards, and turn it into a PCB with minimal redesign.

You can then take your PCB an put it back into your group of breadboards.

In this way, you can convert an all-breadboard prototype to a PCB prototype in small pieces.

You can use the Front of the breadboard as the solder side, if you like.

Mounting according to your needs: drill or ream holes for screws, or slide into box, or any way that works for you.

PCBWAY.com did a great job. The pads stay on, even at 380 C.

Interestingly 10 boards were ordered, and 13 boards arrived. I don't know why.

Manufacturing Parameters:

Board type : Single pieces

Different Design in Panel: 1

Size : 81.3 x 53.3 mm

Layer : 2 Layers

Thickness : 0.8 mm

Min Hole Size : 0.3mm

Silkscreen : White

Surface Finish : HASL with lead

Via Process : Vias not covered

Material : FR-4: TG130

Min Track/Spacing : 6/6mil

Solder Mask : Green

Gold fingers : No

"HASL" to "ENIG": Yes

Finished Copper : 1 oz Cu

Additional Options : UL Marking:None