I always use washing water for washing. I changed N types. Basically, all of them are whitish. Moreover, after washing the boards, they don’t look good before washing. How do you guys wash them? How a...
The page you referred to in your answer to my original question (How can I make my PCB available to others?) shows how to share when ordering the PCB. I can't see how to share it once the order is...
36. about power laying copperAnalog ground, power supply and digital ground, power supply is not the same, in the negative layer isolation. Double-click the isolation area to add a network.37.&n...
Hello everyone!I am a robotics engineer based in London and I have interest in sensing and electronics. As a part of a personal project, I want to design my own EEG setup (potentially to control a rob...
Hi everyone, I would need to import some old orcad files into kicad, can it be done? The gerbers generated by orcad I can not pass them pcb production and I would not know how to do, thanks
I see on your site that the assembled PCB for the Solar Bottle Lamp (LP550) is out of stock.When do you expect to have it back in stock?Can you supply just the bare PCB for me to assemble?If so, what ...
I live in turkey , hard to procure electronic parts . so i will buy the components clone arduino uno and put it on the board I will order from pcbwayI don't know how ...
Hello, I need to make a small 2 layer pcb for a led out of aluminium. On the pcb are 2 through holes for soldering wires (+ and -). Is it possible to have through holes on a alumium pcb or will t...
