I’m working on an Arduino project where I want a motor( currently using a dc motor) to generate electricity and then reverse the polarity if it’s spun the wrong way. Any one know how to achieve this?I...
How to use an TXS0108E bi-directional logic shifter to convert 3.3V signals from a raspberry pi to a 5.0V signal to a relay board. I'm trying to trigger a 5 volt relay board using a raspberry...
Hi all,I'm working on a design that uses a power switch(picture showed below) with a 6-UFBGA package to switch between USB and battery backup power. I will be placing the components by hand a...
Hi everyone,I'm making a device with an SD card slot. The SD card holder is just a surface mount metal shell, and it has 4 foot pads that solder down, and are not electrically connected. I'd l...
Does anyone in Maker Space know the producer of headphone jacks marked with a K in a square? And honestly, who′d thought this was actually soldered onto a PCB? There′s almost no lead on the pins, no w...
I'm in the process of building a project and would like some advice. It's a light-sensitive audio trigger built from a simple circuit interrupted by a photoresistor.However, photoresistors hav...
I get confused about the meaning of simulation and emulation.Could anyone explain the difference in terms of programming? What is the difference between these two terms? Thanks
Hi,I have a design containing 3 identical circuits in a repeated sheet (let's call it rep_sht) which contains a couple of subsheets. I would like to layout the first rep_sht and be able to copy th...
