HelloWhat is the minimum distance between traces/polygons on your PCBs for voltages like 250V or 400V? is 66 mils/1.7mm enough, it could be less, or more?My current desing:
I have two different PCB designs (A and B) that are used in pairs so plan to put both on one panel to minimize NRE costs for assembly. Each board is 75 mm x 85mm. After reading the information on the ...
If I provide a design to PCBWay that will have rails that will be seperated after assembly with a V groove cut, what gerber file extension should be used and/or what note(s) should be added to the ord...
Hello everyone!I have done a layout of a small PCB. Now for a automatic assembly I need to replicate it (put 12 same small PCBs on one big PCB). What is the best way to achieve this in circuit studio?...
I was advised to clean PCB using petrol if alcohol is not available. I tested and found that Petrol and alcohol both works good on PCBs. I have also tried with acetone but it makes white spots on PCB....
