|
|
22pF Ceramic Capacitor |
x 2 | |
|
|
100nF Ceramic Capacitor |
x 2 | |
|
|
5mm Led |
x 1 | |
|
|
10K Resistor |
x 1 | |
|
|
220R Resistor |
x 1 | |
|
|
16MHz Crystal Oscillator |
x 1 | |
|
|
40 Pin Zif Socket |
x 1 | |
|
|
Button 6x6x8.5mm |
x 1 | |
|
|
Header Male 2.54mm 1x6 |
x 1 | |
|
|
Header Male 2.54mm 1x8 |
x 1 | |
|
|
Header Male 2.54mm 1x10 |
x 1 |
|
arduino IDEArduino
|
MIGHTYCORE Programmer
GENERAL INFORMATION
MIGHTYCORE Programmer is an open-source shield for Arduino Uno that facilitates the writing of the bootloader to the ATmega DIP-40 family ICs (MCU 8 bit). On the shield there is a socket for inserting the IC (40-pin Zif), a LED and a 16 MHz crystal oscillator. Despite its simplicity of construction, it greatly helps the production speed of microcontrollers. The supported ICs are:
- ATmega8535
- ATmega16
- ATmega32
- ATmega164
- ATmega324
- ATmega644
- ATmega1284
HOW TO FLASH THE BOOTLOADER
PREREQUISITES
Install the MCUdude (MightyCore) libraries. For the detailed procedure click on the following link:
https://github.com/MCUdude/MightyCore#how-to-install
PROCEDURE
- Upload sketch No. 11 in the examples section to the Arduino Uno;
- Select the desired card in Tools → Card → MightyCore;
- In Tools → Programmer, select “Arduino as ISP (MightyCore)”;
- Still in the Tools section, click on “Write the bootloader”;
- If the procedure is successful, the LED on the shield will start blinking.
MIGHTYCORE Programmer
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(2)
More by Riccardo Cossutta
-
CrossRoad LAB FTDI USB to SERIAL (TTL)
GENERAL INFORMATIONThe USB to Serial (TTL) FTDI is a USB to serial converter, for conversion it uses...
-
MIGHTYCORE Programmer
GENERAL INFORMATIONMIGHTYCORE Programmer is an open-source shield for Arduino Uno that facilitates t...
-
CROSSROAD LAB MICRO 1284P
GENERAL INFORMATIONMICRO 1284P is an open-source microcontroller based on the ATmega1284P. It featur...
-
CROSSROAD LAB MEGA 1284P REV. 1.5
- UPDATE- This update fixed some pcb issues and made it easier to upload sketches through the serial...
-
CROSSROAD LAB MEGA 1284P REV. 1.0
- OUTDATED - Update: Coming SoonGENERAL INFORMATIONMEGA 1284P is an open-source microcontroller base...
-
-
-
-
Tester for Touch Screen Digitizer without using microcontroller
234 2 2 -
Audio reactive glow LED wristband/bracelet with NFC / RFID-Tags
239 0 1 -
-
-
