Gamecube Led Adapter Pcb
IMPORTANT PLEASE READ
Order .6mm or thinner for best fit. First, desolder the black plastic controller port from the controller pcb. Then measure out and solder in leds to the adapter pcb as well as resistors. Then remove the top tabs from the metal controller tabs so more light will shine through if you want. Then place the adapter pcb onto the black plastic controller port back facing you it should snap in. Then place both pieces into the gamecube controller pcb and make sure to get good flow of solder to all the pins I would put a cap leg into the power trace hole so good connection is made for the led pcb.
Gamecube Led Adapter Pcb
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(1)
More by frank strasser jr
-
ARPS-2 – Arduino-Compatible Robot Project Shield for Arduino UNO
317 0 0 -
A Compact Charging Breakout Board For Waveshare ESP32-C3
669 3 6 -
AI-driven LoRa & LLM-enabled Kiosk & Food Delivery System
652 2 0 -
-
-
-
ESP32-C3 BLE Keyboard - Battery Powered with USB-C Charging
854 0 1 -
-
mammoth-3D SLM Voron Toolhead – Manual Drill & Tap Edition
754 0 1
