El Burrito 6cm CW/FM Frontend 5760 Mhz V3
El Burrito 6cm CW/FM Frontend 5760 Mhz V3
V2 of the "El Burrito EB6 Frontend", a 5760Mhz FM/CW Frontend for the 6cm HAM radio band using SE2595L for use with MAX2870 modules or PlutoSDR. RF output if filtered for the 6cm band. Power on 6cm is up to 200mW, RX signal is amplified by 14db. Detailed description is published in DUBUS 1/2023.
Important: Add the following requirements to PCB order:
"Top layer: yellow soldermask, bottom layer no solder mask, just "surface finish" see attached pcb-photo.jpg".
For stencil order use 0.1mm thickness, no frame
Revisions:
V2 adds a SMA Connector for SDR output
V3 adds a filter footprint after the SE2595L, which can also be used as amplifier.
El Burrito 6cm CW/FM Frontend 5760 Mhz V3
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(0)
More by Fred OE8FNK
-
Mezzanine PCB for all El Burrito Frontends
El Burrito Mezzanine PCB for all El Burrito GHz FrontendsThis Mezzanine PCB connects the ESP32 Wifi ...
-
El Burrito 6cm CW/FM Frontend 5760 Mhz V3
El Burrito 6cm CW/FM Frontend 5760 Mhz V3V2 of the "El Burrito EB6 Frontend", a 5760Mhz FM/CW Fronte...
-
El Burrito 6cm CW/FM Frontend 5760 Mhz V2
V2 of the "El Burrito EB6 Frontend", a 5760Mhz FM/CW Frontend for the 6cm HAM radio band using SE259...
-
El Burrito 6cm CW/FM Frontend 5760 Mhz V0
V0 of the "El Burrito EB6 Frontend", a 5760Mhz FM/CW Frontend for the 6cm HAM radio band using SE25...
-
-
-
-
Tester for Touch Screen Digitizer without using microcontroller
230 2 2 -
Audio reactive glow LED wristband/bracelet with NFC / RFID-Tags
236 0 1 -
-
-
