ESP Room SmartMonitor V3
Temperature, humidity and light sensors using ESP8266, with ESPeasy code, to send to Home Automation (HTTP, MQTT, others) the measures. This use 100-240VAC 50-60Hz and a transformer enclosure from TME KRADEX Z10 model.
The idea is to plug this "toy" in a room, measure the temperature and humidity and control a heater accordingly with your convenience (home automation prog.). Additionally, the light sensor can be useful with electric curtains, with home automation program.
The board should be installed in the case cover.
Both sensors (BH1750 and DHT22), 3mm blue LED and RESET switch should be mounted on the bottom/back side of the board, faced to the cover. You must cut a small window on the cover for DHT22 (Temperature and humidity sensor) and round holes for BH1750 light sensor, LED and switch.
ESP Room SmartMonitor V3
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(0)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Julio Santos
-
Open Source Very Large Stick - Freejoy & MMjoy2 breakout board
499 0 0 -
RF Control training board for students based on ESP32 C3
668 0 2 -
Aquarius+ Computer, Standard PCB
890 0 4 -
KINETIC COASTERS with a TWIST! Laser or 3D Print some DIY Magic
605 0 1 -
RPI - 8 IO PLC With ATTiny85 Watch Dog
528 0 1 -
Nintendo Famicom HVC-001 Controller Shells
624 0 1 -
COMMODORE 128 DIAGNOSTIC REV.785260 KEYBOARD DONGLE
587 0 4 -
COMMODORE 128 15KHz DISPLAY ADAPTER (C128 80 COLUMN ADAPTER)
796 1 6 -