### DESCRIPTIONBreakout board to test or programm AVR attiny microcontrollers### TECHNICAL DETAILS / COMPONENTSSocket for all three diferent capsules, use only one at a time.10 leds bank to test your outputs.Two transistors, one bipolar and one mosfet available, base and gate protected by resistors, collector and drain on output pins, emmiter and source connected to GND.header for FTDI comms. adapter, power supply connected and capacitor to reset line connected too, Rx and Tx ready to be connected anywhere you need.Two pushbutton switches with resistor and capacitor network to minimize rebound, one provides high level when pushed, the other provides low level when pushed.Built in power supply, female plug connector, positive at center, and two pin rows, one for positive 5V, and the other for GND.AVR ICSP header for programming, connected to every socket.Two connection per pin on all capsules.### LEARN / TOPIC / BUILD INSTRUCTIONSEnjoy it