good afternoon. is it possible to make a copy of a printed circuit board from a ready-made sample? small changes will be required to the finished product.I send the sample in the attached photo.if req...
How much does using microvia in my board design at to the manufacturing cost?I don't see micro via as an option in the instant quote process.My board is 6 layers, standard 10cm x 20cm.
I am designing a 2-layer PCB, the bottom layer is GND and the top layer is signal and power. The PCB has some sensors and an arduino, also the I2C is used.I'm learning but I am confused about how ...
Hello, I have ordered boards for the Mesa Boogie Emulator and I was wondering if I could get a better copy of the schematics for the 3 versions. The ones posted are too grainy to see the values t...
Hello,is there any tutorial or guideline how to prepare board design for your manufacturing?I use Eagle for the design but I do not have an experience with cooperation with manufacturersI would like t...
Should I link up these ground signals or leave them?PCB I'm working on has a main board and then smaller secondary boards which contain external components. Everything is isolated and has its own ...
