Hi, I've been designing a keyboard pcb, and I'm a bit confused about GND and no net zones, as in when I should use them( both layers, or just one? Also, should I have isolated copper fills at ...
If "LIGHT AND MOTION SENSITIVE LAMP" circuit run by 220VAC then will it automatically power the sensor and relay or separate DC power needs to apply?Why there are two relays in above c...
Hello! I am senior technician of the company "Ateko-TM", Valery.We need to produce special flexible doard for our new project.The main board characteristics (mm): Size: 20 x 40 (fo...
Is it a component? Came across it when converting my schematic to PCB. How do I get this in my schematic when I am supposed to recreate this schematic in Eagle?
I am looking at designing a 2 layer PCB with through hole components that will sink 10 Amps of current. I understand that I need to make the width of my trace large enough to handle 10 Amps. My questi...
I need to duplicate high current tracks front and back. I have stitched vias and made a custom through-hole pad, also with stitched vias.However I can't get the last via-to-pad track to remain. If...
