Hi to all!I always used SPI devices in low speed mode, now I need to push SPI clock at maximum device speed.I'm using ADXL355 on evaluation board, directly connected to PIC microcontroller through...
Hello, I need to make a small 2 layer pcb for a led out of aluminium. On the pcb are 2 through holes for soldering wires (+ and -). Is it possible to have through holes on a alumium pcb or will t...
I want to make a PCB as one design, but with a part as a 'break-off' section - see the picture with the large slot near the top of the board. The board measures about 130 x 100mm overall.Is this the b...
Hello can you please explain me how to order PCB-SPower supply for tube amplifiers 1pcsPush Pull Tube Amplifier el34 2pcsThank You for answer!With friends Regards!Andrej
In order to implement a successful PCB design using motor driver ICs, the PCB must be carefully laid out. Can you provide some practical suggestions, hoping to help PCB design to achieve the good elec...
I designed a panel pcb board, but the edge rail without copper, I sometimes receive EQ suggestion edge rail for copper，Is there anything special about it?
