PCBWay RP2040 ESP12F IoT Module-Support Arduino,MicroPython and CircuitPython
PCBWay RP2040 ESP12F IoT module supports multiple languages including C/MicroPython/CircuitPython, which greatly improves its ease of use.
In addition, it has the same RP2040 chip as the Raspberry Pi RP2040 ecosystem, meaning they are compatible. PCBWay RP2040 ESP12F IoT module will be a wonderful tool for you to start using MicroPython.
Features：
High Performance: Powered by Raspberry Pi 2040 chip, dual-core operating up to 133 MHz, equipped 264KB of SRAM, and 2MB of onboard flash memory.
Small Design: 60 x 90mm, Wit ESP8266 and 0.96’’ oled interface, suitable for wearable devices
Multiple Develop Platform: Support Arduino / Micropython / CircuitPython development
Raspberry Pi RP2040 Microcontroller Chip is the debut microcontroller from Raspberry Pi. It brings high performance, low cost, and ease of use to the microcontroller space. The RP2040 has a large on-chip memory, symmetric dual-core processor complex, deterministic bus fabric, and rich peripheral set.
ESP-12F module core processor ESP8266, integrates industry-leading Tensilica L106 in a smaller package, ultra-low power consumption 32-bit micro MCU, with 16-bit simplified mode, main frequency supports 80 MHz and 160 MHz, supports RTOS , integrated Wi-Fi MAC/BB/RF/PA/LNA. ESP-12F Wi-Fi module supports standard IEEE802.11 b/g/n protocol and complete TCP/IP protocol stack. Users can use this module to add networking capabilities to existing devices, or to build a stand-alone network controller.
Note: The RX and TX0, TX and RX1 are respectively connected with two 2.54mm jumper caps, rp2040 can call esp8266
- Comments(0)
You might like
-
-
-
-14%
PCBWay RP2040 ESP12F IoT Module-Support Arduino,MicroPython and CircuitPython$19.99 or 2400 BeansBUY NOW
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
