Sensors Community

The MySensors Micro is a tiny Arduino compatible board stackable with a Nordic NRF24L01+ transceiver module. The Micro has been designed for extended battery life; e.g. it operates directly at the battery voltage without the need for power regulators for low power consumption. As it has been designed to sleep most of the time, the operating frequency (8Mhz vs 1Mhz) is not that big a factor on battery consumption, hence the Micro is running at 8Mhz as default to facilitate the easiest adoption of sketches. Even in its small form factor it's packed with great features such as temperature and humidity sensor, 64k extra flash memory and a hardware module for secure message signing and verification.Need more? Expand the functionality by attaching additional breakout sensors to the five digital GPIOs, two analog inputs or the I2C interface.The board has been preloaded with a sketch reporting temperature and humidity levels every minute.Technical SpecificationVery small footprint, 30 mm x 17.5 mm (1.18in x 0.69 in). Making it almost same size as the NRF24 module.Arduino IDE 1.5.x & 1.6.x compatible.Si7021 integrated humidity / temperature sensor.64kb SPI flash / e2prom onboard. Useful for over-the-air firmware updates. Also possible to use memory for a local sensor data cache.ATSHA204A on board (connected to A3). Used for HMAC-SHA256 message authentication support.Runs directly off 2x1.5V batteries (AA or AAA), without power converters.Socket* for connecting the radio module on top.Pin-headers* for D3-D7 on one side, and SDA/SCL + A0/A1 and power on the other side.FTDI header similar to Arduino Pro Mini.Standard Atmel programming ISCP header.Pads for mounting a 32Khz crystal (when timing is crucial).Status LED (on A2).Factory programmed with DualOptiBoot bootloader.You have to solder the radio socket, and pin-headers yourself if you need them mounted. Note: The actual NRF24L01+ module is sold separately.Available pinsPowersupply (1.8 -> 3.5V)SDA / SCL (I2C bus)A0 / A1 D3 / D4 / D5 / D6 / D76 pin ISP port8 pin standard NRF24L01+ connector layoutFTDI header for serialWiring Things UpNOTE! Maximum allowed supply voltage is 3.5V, anything above this WILL fry both Si7021, flash and NRF24 radio module. There is NO voltage regulator on board (To keep supply current down to a minimum)Connecting FTDI ProgrammerTo upload a new sketch to your Micro board use a FTDI programmer. Remember to set it a 3v3 output using the jumper setting on the programmer.Connecting ISP ProgrammerMake sure the red-dotted ISP wire goes into ground on the board. Disable power feeding on 5V ISP programmers (remove jumper) and power up the board on VCC/GND from a 3V power source.Available PinsThis picture shows all the available pins on the Micro board. Click on the image to enlarge it. The ISP connector exposes MISO, MOSI, SCK and RST.Mounting RadioThe radio can be soldered directly onto the board or in a socket.

Hall sensor module OH34N

EEPROM storage module 24C02

MySensor Micro

24 bit differential ADC module CS1237

Custom ADS1256 board with ATmega32U4

Analog Switch Module x 4

The PCBWay that recognize the talent and effort of the best ELECTRONIC designers in the World.