LCC-PNET-Router
This is a "router" between a LCC network and a Pricom Lighting PNET network.
It translates between LCC event reports and PNET Trigger, Control, and Dimmer
messages. The PCB contains CAN transceivers for the two CAN IFs on a
PocketBeagle, with one wired to LCC network connectors (RJ45s) and the other
wired for PNET (RJ12 6-6). The "firmware" compiles and runs on a 32-bit ARM
Linux SBC (tested on a Beagle Bone using GridConnect over Tcp/Ip for the LCC
network and the Virtual CAN driver (vcan) for the PNET network.
LCC-PNET-Router
Project images are for reference only. Actual production is based on the manufacturing files on the project page.
Please review the designer's notes (e.g., PCB thickness) and select the appropriate options.
PCBWay is not responsible
for issues caused by unsuitable parameter selections.
For more important ordering information, please refer to
Read More
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(0)
More by Robert Heller
-
LCC-PNET-Router
This is a "router" between a LCC network and a Pricom Lighting PNET network.It translates between LC...
-
Universal LCC Node Breakout
This is a "Breakout" board containing a 3.3V CAN transceiver, LCC RJ45 connectors, and 12V off the L...
-
Universal LCC Node Breakout
This is a "breakout board" for use in breadboarding LCC nodes, typically using breadboard friendly M...
-
ESP32 Quad Stall Motor Controller with Point Sense
This is a circuit board that supports an ESP32 Dev Kit board or TTGO-T1 board controlling four stal...
-
Pocket Beagle Quad StallMotor w/Sense base board, includes LCC CAN and power supply
This is the improved Quad Stall Motor Controller w/ point Sense base board for the Pocket Beagle. I...
-
Quad Stall motor with point sense cape
This Beagle Bone Cape implements four Stall motor drivers with point sense to your Beagle Bone. It ...
-
LCC CAN Cape for Beagle Bone Black
This cape puts your Beagle Bone Black on your LCC/OpenLCB network (http://www.openlcb.org/). This le...
-
Quad Stall Motor Controller w/ point Sense "hat"
This is the improved Quad Stall Motor Controller w/ point Sense "hat" for the Raspberry Pi. It use...
-
Programmable Mist Maker - XIAO / QT PY Extension
1825 2 2 -
RadioHAT - Raspberry Pi radio development platform
1557 0 3 -
-
-
-
ARPS-2 – Arduino-Compatible Robot Project Shield for Arduino UNO
3787 0 6 -
A Compact Charging Breakout Board For Waveshare ESP32-C3
4537 3 8 -
AI-driven LoRa & LLM-enabled Kiosk & Food Delivery System
5341 2 2 -
