|
KiCad 9.0 |
|
|
Fusion 360Autodesk
|
Magnet Ring Cap Sensing for Automatic Medication Adherence Logging
A lot of people take long term meds and will often miss taking them. Most tracking devices require additional actions such as button presses or opening apps to make note of taking medication. I have created a stand and magnet ring cap to automatically track how many times a prescription bottle has been opened.
The 32 small magnets are placed around the bottles existing lid. The stand has a magnetic sensor that notices when the magnets on the cap move away. If the cap stays off for at least 2 seconds, the board counts it as one opening. When you put the cap back on, the board saves that time in its memory and sends a message to your phone. A screen on the stand shows the last 4 times the bottle was opened, so you can check without using an app (Screen goes on the 4 female-pin headers).
The system was created using a custom 2 layer KiCad board (Rev 2). The board uses an ESP32-C3 with Wi-Fi. There is a low power Hall sensor that detects the magnet ring and an accelerometer that wakes the board when the stand is moved. The accelerometer is only there to wake the board. The board also has a DS3231 RTC for keeping track of the time and a 24LC256 EEPROM to store up to 4095 events. The board will be asleep most of the time but will wake when the magnet is moved away from the board or the stand is touched. The board can be charged via USB-C with a TP4056 and DW01A battery protection circuit. The board has a 1.5 inch OLED screen displaying the status of the system and recent openings (since its not soldered on you can customize this). The stand and topper were 3D printed. The topper can fit caps of around 47.6mm.
This is useful as it can be used with your existing bottle. No moving of pills to a specific container is required. No buttons or scanning is required. The caregiver will receive a phone notification when the bottle is opened. The system is dependent on bottle size.
Magnet Ring Cap Sensing for Automatic Medication Adherence Logging
Project images are for reference only. Actual production is based on the manufacturing files on the project page.
Please review the designer's notes (e.g., PCB thickness) and select the appropriate options.
PCBWay is not responsible
for issues caused by unsuitable parameter selections.
For more important ordering information, please refer to
Read More
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen(Without Speaker)
BUY NOW- Comments(0)
- Likes(3)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Engineer
-
-
BorePilot - ESP32-S3 Smart Borewell Pump Controller
256 0 0 -
-
-
AudioLink – USB & Bluetooth LE Audio / Auracast Receiver with Balanced Line Outputs (nRF5340)
419 0 1 -
-
-
-
Émetteur Récepteur Optique Expérimental (communication UART ATtiny + fibre optique)
437 0 1 -







