Flipper Zero tester board
This board is designed for the Flipper Zero and to be used with 3 specific Flipper Zero application:
- "Servo Tester"," Servo Tester 2": test zero using the A6 pin
- "Temp sensor reader" to read Dallas, DHTxx and lot of different I2C temperature and humidity sensors (using A7 as data pin, C0 and C1 for I2C)
- "i2c Tools": test i2c devices, for example determine the i2c address
To assemble this board you need a right angle pin header (a longer version to make sure it reaches into the Flipper Zero), and also a few female or male pin header (all standard 0.1 inch pitch).
I left a footprint for a pullup resistor for the Dallas 1-wire chip. Sometimes it is included in the DS18B20 DIY boards. It is up to you to populate it, or leave out.
Watch a detailed video on this board here: https://youtu.be/34OTaEBBVH0
Flipper Zero tester board
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(1)
- Likes(4)
More by Csongor Varga
-
Flicker free train light
This small circuit board is a power buffer for a model train coach lights, to provide flicker free l...
-
Flipper Zero tester board
This board is designed for the Flipper Zero and to be used with 3 specific Flipper Zero application:...
-
Modbus to MQTT board version 2
This is my second version of the ESP Modbus board (first version: https://www.pcbway.com/project/sha...
-
Input Selector
I am using this board to pre-select power supply for me garden layout. I primarily use Marklin Digit...
-
Home Sensor Board
I built this board so I can assemble various ESP8266 based sensors using easily available breakout b...
-
Wifi Throttle
This project is created for my Wifi LokRemote project (https://github.com/nygma2004/Wifi_LokRemote) ...
-
ESP32 Wifi LocoRemote
This project is a wifi controller for large scale garden railway locomotives. It uses a ESP32 microc...
-
RFID, iButton MQTT Access Control
This ESP8266 sketch communicates with a Wiegand RFID reader and keypad. Ket features:Connect ot loca...
-
PxMatrix ESP8266 Driver
This is my simple PCB design to drive Px Matrix displays with an ESP8266.So far I have used this to ...
-
ESP8266 Modbus board
This board uses an ESP8266 and an RS486 to TTL converter to allow the ESP to access devices over Mod...
-
DHT22 Sensor Node with ESP8266-01
### DESCRIPTIONI was asked to create 10 temperature sensors for a Blynk project. I designed to above...
-
Station Announcement for model train layouts
### DESCRIPTIONI am building a model train layout with my kids. I decided to add station announcemen...
-
-
-
-
Tester for Touch Screen Digitizer without using microcontroller
230 2 2 -
Audio reactive glow LED wristband/bracelet with NFC / RFID-Tags
238 0 1 -
-
-
