Christmas is here and Silicon Lab is happy to offer you the best. This Christmas 2019 we are offering a Santa Claus module for Arduino.

Through this module you will be able to control your Santa Claus hand, eyes and your bonnet.

In addition to, you can control the song through passive buzzer and use the button to control some functionality with Arduino.

Below, in the Figure 1 we have a electronic schematic to easier your assembly process and understand how the circuit was created.

Figure 1 - Electronic Schematic of the Santa Claus Arduino Module.

As is possible see, was used a male header with 8 pin. In each pin was connected the 4 LED's of 5 mm, the passive Buzzer and a Button for general purpose.

After construct the circuit, was created the Printed Circuit Board, as is shown in the Figure 2.

Figure 2 - Santa Claus Printed Circuit Board.

After this, the user can buy the electronic components, solder and create good christmas projects with Santa Claus and the Arduino.

Hereafter, we'll show the 3D printed circuit board of the Santa Claus Arduino Module in Figure 3.

Figure 3 - Santa Claus Arduino Module in 3D View.

Therefore, through this project you can use it in your arduino projects and, too, you can use it in activities to solder. For this, enjoy the PCBWay CHRISTMAS10 to earn $10 of discount in your next order.