1answers

[Others] Should I connect isolated areas of ground pour?

As it shows, there are two isolated areas of the ground pour. I'm using Eagle, so when I do the pour it does not place in these type of areas unless I explicitly place a via where the bottom...
2answers

[Others] Stencil design for BGA components in Eagle. should I disable the tCream layer for this package?

Hi all,I'm working on a design that uses a power switch(picture showed below) with a 6-UFBGA package to switch between USB and battery backup power. I will be placing the components by hand a...
  • answered Jul 13,2020
    by Andrew
2answers

[Others] Eagle question: How to ground the mechanical pads of a part?

Hi everyone,I'm making a device with an SD card slot. The SD card holder is just a surface mount metal shell, and it has 4 foot pads that solder down, and are not electrically connected. I'd l...
  • answered Jul 13,2020
    by Joson
Ranking Name Answers
1 PCBWay Team 8
2 Frederic 3
3 Engineer 1
4 Jegatheesan Soundrapandian 1