4answers

[Others] How can I clean off tacky flux?

I've been using tacky flux to solder small pin-pitch packages with a flat tip, and it's been awesome. But it is quite a terrible time when it comes to cleaning. I've tried 70% isopropyl al...
16answers

[PCB Prototype] How should I solder these pins, they are tucked under the chip.

I plan to put solder on a corner pad, place the chip and solder that pin, then do the rest one by one. The problem I foresee is that it's almost impossible to see bridged pins because they're ...
2answers

[Others] Can I extend a 4 pin tact switch just using wires?

I want to move it to another position but don't know if it'll work. Any tips for that?
10answers

[PCB Prototype] How would I desolder these switches?

This remote control, used to control my blinds, and I wanted to replace the buttons (switches?) on it with a relay board controller, so that I could use the remote from a raspberry pi instead of havin...
4answers

[Others] Can I solder it back on?

While working on ds4 controller this capacitor fell off, is it needed?
  • answered Sep 02,2020
    by Kemio
4answers
1 2
Ranking Name Answers
1 PCBWay Team 8
2 Frederic 3
3 Engineer 1
4 Jegatheesan Soundrapandian 1