"Failed reason: Please confirm if it is a 1-layer or 2-layer board."How do I specify that a board is 1-layer or 2-layer? (I already set this when submitting the order.)Do I contact somebody?...
Hi,This is a button shield I am creating for use with a Digispark.As I have never designed a PCB, I just want to make sure that this looks like it should function properly. Other than having GND conne...
I have a very small and thin PCB I am trying to design to work in a very small space. Essential trying to only solder a SOT-23 to another SMD chip, hoping to mount them on either side of a double laye...
36. about power laying copperAnalog ground, power supply and digital ground, power supply is not the same, in the negative layer isolation. Double-click the isolation area to add a network.37.&n...
is there any ULP, which can remove very small gaps between two lines. I am facing this issue, when i am trying to import DXF file. There are lots of lines, where this small gaps(0.0001% of gaps) occur...
Hello everyone!I am a robotics engineer based in London and I have interest in sensing and electronics. As a part of a personal project, I want to design my own EEG setup (potentially to control a rob...
