Greetings. I have a request to make: can you produce a board based on the schematics I provide? Every component - resistor and capacitor are of SMD 0805 sizeActual values of resistors and capacitors c...
I need to place an SMA connector on the side of my board, but I am unclear how PCBWay would deal with a pad being placed that close to the side of the board. (They specify it should not be less than 0...
Hi I saw a Bob Beck electrifier here...https://www.pcbway.com/project/share/Zapper_Bob_Beck_beccfc49.html. I would like to order 5 of themRegards Franck
Hi, i like to create a board for my esp32 devkit edrums project.I like to have 12 input for the piezo pads, every input will be connected with 1M ohm resistor and a zener diode in parallel mode and ev...
I have an old piece of heavy equipment. A control board on it has gone bad that is no longer made. Is it possible to send this in to PCB way and have the board replicated?
Hi,according to the BOM this project contains socketed IC.How will you do assembling?Just placing & soldering the sockets or seating the IC on the sockets as well?What about those parts like conne...
