Trying to build the emergency light. Could you please give me the value for the trim pot you used and the zenner diode. and also the component list says 5R 2W for the 2 watt resistor however the mark...
I'm interesed in ordering the Wandy Amaury Dual ESP32-C6 gateway PCB Proyect board, but i would need the ESP32 to be the WROOM-1U version instead of the WROOM-1
in electronic circuit Coupling capacitors are used in series to allow only high-frequency signals to pass to the system load, as in the following image. Decoupling capacitors, also known as bypass cap...
In-Ears headphones use magnetic dynamic drivers. If you bring the in-ears close to an electronic device that releases magnetism with a 29" CRT TV (coils, speaker) turned on, will this TV cause demagne...
Hi, are you guy's able to install male and female NEMA 5-15P connectors into a mold injected part that is manufactured by pcbway? and if so, where would you source it from?(I sent a few pictures ...
I would like to ask if you will be able to procure one of the following USB-C connectors, as I want you to assemble them in a future project:https://www.digikey.com/en/products/detail/assmann-wsw-comp...
Good morning! First off, thanks for making this open source. I love all of your work. I am in the process of ordering parts and have a question about the values of L1 and L2 on the processing board fo...
Manufacturers of aluminum electrolytic capacitors in storage recommend energizing these components once every 1 or 2 years and the temperature range is 5-35C and humidity is below 75C. After this inte...
