Francesco Berghi
ITALY • + Follow
Description
d-diot hub v.3.0 - board B
With this PCB you can build the d-diot hub v.3.0-B, which is:
- An IR Gateway (transmitter and receiver) based on ESP32
- A 433 Mhz RC Gateway (transmitter and reciver) based on ESP32
- A step-up and step-down voltage regulator with target voltages adjustable in the firmware based on Arduino
This IoT hub was meant to be used with Home Assistant and it has a modular design, so it can be combined with the hub A.
The case is 3d printable and available in thingiverse, the firmware for each module is available in github while all the details and the build instructions are in the dedicated wiki page.
Schematic and Layout
https://wiki.d-diot.com/getting_started/hub_v3.0/start
Mar 01,2021
1,491 views
d-diot hub v.3.0 - board B
2 Layers PCB 100 x 100 mm FR-4, 1.6 mm, 1, HASL with lead, Green Solder Mask, White silkscreen
With this PCB you can build the d-diot hub v.3.0
1491
1
0
Published: Mar 01,2021
Standard PCB
PCBWay Donate 10% cost To Author
Only PCB
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Under the
Attribution-ShareAlike (CC BY-SA)
License.
- Comments(0)
- Likes(1)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
More by Francesco Berghi
-
d-diot hub v.3.0 - board B
With this PCB you can build the d-diot hub v.3.0-B, which is:An IR Gateway (transmitter and receiver...
-
d-diot hub v.3.0 - board A
With this PCB you can build the d-diot hub v.3.0-A, which is:A dual wifi MySensors gateway (RFM69 an...
-
USB Smart Hub
With this MySensors node you can turn on/off 3 USB type A ports; the power state of each USB port ca...
-
d-diot multi-purpose IoT pcb
This small PCB (55×35) is born to be a general purpose solution for building any kind of compact wir...
-
d-diot battery powered Multisensors
This battery powered multi-sensor is based on an ATMega328P MCU (Arduino) plus a radio module (NRF24...
-
A 3d printable wifi mood lamp with ESP8266 and WS2812B LEDs
This mood lamp is part of the d-diot project, which is an open project for hobbyist, makers, and eve...
You may also like
-
-
-
-
Tester for Touch Screen Digitizer without using microcontroller
228 2 2 -
Audio reactive glow LED wristband/bracelet with NFC / RFID-Tags
233 0 1 -
-
-
