|
|
FreeCADFree Software Foundation, Inc.
|
Sharp MZ-700 Keyboard Key Post
This is a replacement keyboard key post for the Sharp MZ-700 series of computers.
Check for a smooth sliding action between the side guides in the keyboard and the post. If that checks out carefully transfer the rubber pad over from the broken post to the new one. Insert the post into the keyboard, insert the spring or springs depending on the key, and snap it into place on the post. Make sure it is fully seated.
Print this in resin, not suitable for FDM. Some sections are very thin, so you may get a warning.
Sharp MZ-700 Keyboard Key Post
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(1)
More by OMPea Retro
-
Sharp MZ-700 Keyboard Key Post
This is a replacement keyboard key post for the Sharp MZ-700 series of computers.Check for a smooth ...
-
Sharp X1 Turbo Gotek Caddy
This caddy mounts in place of the original floppy drive on a Sharp X1 Turbo allowing you to mount 1 ...
-
Sharp X1 Twin Dual Gotek Caddy
This caddy mounts in place of the original floppy drive(s) using 2 of the 4 original mounts and scre...
-
ARPS-2 – Arduino-Compatible Robot Project Shield for Arduino UNO
112 0 0 -
A Compact Charging Breakout Board For Waveshare ESP32-C3
592 3 4 -
AI-driven LoRa & LLM-enabled Kiosk & Food Delivery System
584 2 0 -
-
-
-
ESP32-C3 BLE Keyboard - Battery Powered with USB-C Charging
794 0 1 -
-
mammoth-3D SLM Voron Toolhead – Manual Drill & Tap Edition
726 0 1
