I designed a corner mount for the magnetic bed of the Voron 3D printer. Aligning the magnetic bed can be challenging due to the strong magnets, so I created these metal corner guides to simplify the process.

Installation is straightforward: just remove the bed and secure the mounts using two M3 screws. Make sure to heat up the bed before tightening the screws to ensure proper alignment. The same piece is used for both corners.

Be cautious of potential collisions with the toolhead. In my case, I had to raise the toolhead slightly when doing timelapses, as the corner pieces extend 1–2 mm above the bed surface.

You can also choose to anodize your pieces to match the aesthetics of your 3D printer—as I did in my case with purple.

If you're interested in the Voron build, here’s the link to my YouTube video: