|
EagleAutodesk
|
RP2040 Biscuit
Basically it's just the bare bones hardware needed to get an RP2040 running. It has no components on the bottom and castellated pads so you can solder it directly to a daughter board like an RF module. It has 2 2020 Neopixel RGB LEDs, MicroUSB-B for power/programming, RESET and USB_BOOT tactile switches, and a Qwiic/StemmaQT connector. You can power it through GPIO or USB. It has 4 analog in pins and 16 GPIO pins, 8 of which can be configured for use with the RP2040s 8 PIO state machines.
RP2040 Biscuit
Project images are for reference only. Actual production is based on the manufacturing files on the project page.
Please review the designer's notes (e.g., PCB thickness) and select the appropriate options.
PCBWay is not responsible
for issues caused by unsuitable parameter selections.
For more important ordering information, please refer to
Read More
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(3)
- 1 USER VOTES
- YOUR VOTE 0.00 0.00
-
10design
-
10usability
-
10creativity
-
10content
More by Firstname Lastname
-
-
-
AudioLink – USB & Bluetooth LE Audio / Auracast Receiver with Balanced Line Outputs (nRF5340)
278 0 1 -
-
-
-
Émetteur Récepteur Optique Expérimental (communication UART ATtiny + fibre optique)
357 0 1 -
SmallOLED - Live PC Stats, Animated Clocks & Audio Visualizer
1427 0 3 -
"Talking Multimeter": Arduino-Based Speech Add-on for Multimeters with SCPI Protocol
797 0 1
