Top Solder Mask
Top Overlay
Top Copper Layer
NC Drill
Bottom Solder Mask
Bottom Copper Layer
Bottom
Top
PICAXE 08M2+ TESTBOARD !
This PCB Board is to be used "as is" for testing purposes.
It is intended for the PICAXE 08M2 and 08M2+.
There are Push Buttons (6x6 mm) and LEDS that can/can not be installed at will.
There is also a small part of the Board that can be used freely for other purposes.
All possible/necessary components are printed on the PCB as an Overlay !
Don't forget the 5V Regulator (provision is made for TO92 or TO220 type IC)
VCC is 9 to 12 Volts. (there are also through holes on the left for this)
SIn : Serial In (C.5) thru 22K and 10K resistors.
SOut : Serial Out (C.0) direct and lights up the C.0 LED !
GND : Ground !
This is a project I made for me, but if it can be shared, well why not ? (!)
Have Fun !
PICAXE 08M2+ TESTBOARD !
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(1)
More by Flash
-
-
-
-
Tester for Touch Screen Digitizer without using microcontroller
232 2 2 -
Audio reactive glow LED wristband/bracelet with NFC / RFID-Tags
238 0 1 -
-
-
