**********IMPORTANT*********** (Do not order, there's a new revison available ( here  )- unless you take note of the following info)

If the cable that comes with your BLTouch has a fixed 1x3 wire block for attaching to the breakout pins, then you need to swap the 5V and GND around.

see this video: https://youtu.be/ocAeZRPVusw?t=341

otherwise if you have seperate du-pont style connectors then attach (or solder directly) the wires making sure 5V and GND goes to the correct marked Pins.

I will create a new revision soon with the pins the right way round.

Description

A simple board to adapt a BLtouch into an ender 3 without splicing cables

Required Ccomponents

H1: 1x 2x5 2.54mm pitch female header socket

P1: 1x 2x5 2.54mm IDC male receptacle

CN1: 1x 1x3 2.54mm JST XH receptacle or header pins

Add the IDC and  XH receptacles to the silkscreen side and the female header to the underside and voilla! you have a passthrough with a tap into GPIO 27 (Sig) and a 5V, GND to power the BLTouch