Airspeed_SensorBoard
Airspeed_SensorBoard
STM32F030F4P6TR
Features
• Core: Arm® 32-bit Cortex®-M0 CPU, frequency
up to 48 MHz
• Memories
– 16 to 256 Kbytes of Flash memory
– 4 to 32 Kbytes of SRAM with HW parity
• CRC calculation unit
• Reset and power management
– Digital & I/Os supply: VDD = 2.4 V to 3.6 V
– Analog supply: VDDA = VDD to 3.6 V
– Power-on/Power down reset (POR/PDR)
– Low power modes: Sleep, Stop, Standby
• Clock management
– 4 to 32 MHz crystal oscillator
– 32 kHz oscillator for RTC with calibration
– Internal 8 MHz RC with x6 PLL option
– Internal 40 kHz RC oscillator
• Up to 55 fast I/Os
– All mappable on external interrupt vectors
– Up to 55 I/Os with 5V tolerant capability
• 5-channel DMA controller
• One 12-bit, 1.0 μs ADC (up to 16 channels)
– Conversion range: 0 to 3.6 V
– Separate analog supply: 2.4 V to 3.6 V
• Calendar RTC with alarm and periodic wakeup
from Stop/Standby
• 11 timers
– One 16-bit advanced-control timer for
six-channel PWM output
– Up to seven 16-bit timers, with up to four
IC/OC, OCN, usable for IR control
decoding
– Independent and system watchdog timers
– SysTick timer
• Communication interfaces
– Up to two I2C interfaces
– Fast Mode Plus (1 Mbit/s) support on
one or two I/Fs, with 20 mA current sink
– SMBus/PMBus support (on single I/F)
– Up to six USARTs supporting master
synchronous SPI and modem control; one
with auto baud rate detection
– Up to two SPIs (18 Mbit/s) with 4 to 16
programmable bit frames
• Serial wire debug (SWD)
• All packages ECOPACK®2
HT7533-1-SOT89
EOL Notification Holtek hereby formally gives End Of Life (EOL) notification that the HT7530, HT7533, HT7536, HT7544 and HT7550 (hereinafter denoted as HT75XX) 100mA Voltage Regulator will be phased out of production with a latest purchase date of July 31st 2003. The suggested replacement device will be known as the HT7530-1, HT7533-1, HT7536-1, HT7544-1 and HT7550-1 (hereinafter denoted as HT75XX-1) and will offer superior performance by providing lower output voltage tolerance of 3% in addition to having an additional SOT25 packaging type. The following shows the phase out schedule for the HT75XX and the cross references between the phased out devices and the new release devices: Last time buy date: July 31st 2003 Order placement deadline Production stops: October 31st 2003 Cease production Last delivery Product reaches end of life status Suggested replacement device: HT75XX-1 Output voltage tolerance of 3% Additional SOT25 package release All devices are now available Refer to the following tables for cross reference information.
Airspeed_SensorBoard
*PCBWay community is a shared platform and we are not responsible for any design issues.
- Comments(0)
- Likes(0)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Beytullah Gültepe
- Schematic 6 Stage Led Chaser Using Transistor Schematic 6 Stage Led Chaser Using TransistorSchematic 6 Stage Led Chaser Using Transistor Thanks to...
- how to make Automatic cut off 12 volt battery charger NE555 SA555 - SE555Features■ Low turn-off time■ Maximum operating frequency greater than500 kHz■ Tim...
- FM RADIO BEYTSEL Fm Radio Receiver 4 TransistorsFm Radio Receiver 4 TransistorsHere is a very simple and effective ci...
- Flip Flop NEW Flip-Flop CircuitFLIP-FLOPThere are electronic elements whose outputs are stable in two ways with th...
- A Single Battery to Drive Your 5V Loads, Using a 1.2A 96%-Efficient DC to DC Boost Converter The rated voltage of single-cell batteries (such as Lithium-ion/Polymer) is below 5V, which is unsui...
- -NE555 Led Flasher Circuit NE555 LED FLASHER CIRCUITDESCRIPTIONThe 555 monolithic timing circuit is a highly stable controller ...
- How to make powerful inverter 12v to 220v , sine wave , irfz44n How to make powerful inverter 12v to 220v , sine wave , irfz44nThe SG3525A series of pulse width mod...
- -LM7812 Voltage Regulator LM7812 VOLTAGE REGULATORVIN = MIN 15V DCVOUT = 12V DCThe LM340 and LM7805 Family monolithic 3-termin...
- High Power DC to Dc Step Up Boost converter 0-30v Adjustable High Power DC to Dc Step Up Boost converter 0-30v AdjustableThe LM7812 is a three-pin positive volta...
- Police_Light POLICE LIGHTAre you ready for the police lights?As you can see, I made the police lights in the circ...
- Metal Detector METAL DETECTOR Metal detectors work Metal detectors work by transmitting an electromagnetic field fr...
- Basic current constant or current regulator using 7805 7805I am going to show the working of a constant current battery charger circuit. They use a few com...
- 3- DC Motor Speed Control Circuit DC Motor Speed Control CircuitYou will be able to control the speed of your engine much more easily ...
- Automatic Fading ON and OFF Circuit using BC847, BC557, Capacitor and Resistor Automatic Fading ON and OFF Circuit using BC847, BC557, Capacitor and Resistor When energized with +...
- 1- 24V Battery Level Indicator 24V BATTERY LEVEL The circuit I designed is suitable for 24V batteries. You include the + and - ends...
- Simple DC voltage booster circuit Without Coil Simple DC voltage booster circuit Without CoilHello everyone,I made a simple and powerful DC to DC b...
- Soft Start Circuit BD139Description These epitaxial planar transistors are mounted in the SOT-32 plastic package. They ...
- Mosfet-Motor Driver Modul MOTOR DRIVER MODULE IRF520NFEATURES • Dynamic dV/dt rating • Repetitive avalanche rated • 175 °C ope...
-
Open Source Very Large Stick - Freejoy & MMjoy2 breakout board
490 0 0 -
RF Control training board for students based on ESP32 C3
654 0 2 -
Aquarius+ Computer, Standard PCB
864 0 4 -
KINETIC COASTERS with a TWIST! Laser or 3D Print some DIY Magic
595 0 1 -
RPI - 8 IO PLC With ATTiny85 Watch Dog
519 0 1 -
Nintendo Famicom HVC-001 Controller Shells
619 0 1 -
COMMODORE 128 DIAGNOSTIC REV.785260 KEYBOARD DONGLE
578 0 4 -
COMMODORE 128 15KHz DISPLAY ADAPTER (C128 80 COLUMN ADAPTER)
780 1 5 -