Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
Next step in the scanner's evolution. It's almost perfect. V1.43 will be the final version without changing components. Then in the distant future I'll design a V1.44 version in which I replace the DI...
This is the 5th iteration of my project to talk to CCD/SCI-bus equipped Chrysler/Dodge vehicles (and apparently John Deere tractors too). It is programmable via ISP-programmers and USB connection (CP2...
This small PCB is used to invert UART-signals that pre-1996 Chrysler/Dodge/Jeep vehicles used for diagnostics. To be used with Engine Connector V1.00. The inverter functionality can be enabled/disable...
This is the longest running project of mine. I modified the connectors on the back to be consistent. Be ready for the V1.42. And of course, PCBWay for the win!
This is the 3rd iteration of my project to control high power RGB LEDs (100W). It is wireless thanks to an ESP32-WROOM-32 module. It can be controlled via I2C if necessary too. It is programmable via ...
This was my very first experience with PCBWay and I was blown away. I used to make PCBs myself in an UV exposure box but I had enough. Quality and price is excellent. Since 2016 PCBWay is my goto fab ...
This is an LM3404 based 3-channel high-power RGB-LED driver prototype. Originally designed to drive a single 100W RGB-LED but changing a few components makes it flexible to go down with the power. Thi...
This is my second attempt to design a programmable water pump controller. It's capable to drive a variety of pumps using 12/24V power source up to a few amps of current. It has a "big" N-MOSFET capabl...
First introduced along with Chrysler CCD/SCI Scanner V1.42 this small PCB allows the user to interface with an OBD1 diagnostic connector (SCI-bus) used in pre-1996 vehicles made by Chrysler/Dodge/Jeep...
Slightly modified version of V1.30. I considered another type of ground vias (smaller than the previous ones and not exposed). PCBWay for the win!
I designed a vertical hydroponic garden from 3D-printed parts and needed a controller to turn the water pump on and off when required. So I designed my own controller board around an ATmega328P microc...
To find out more about this project: https://chryslerccdsci.wordpress.com/