Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
Back left arm. Holes made small on purpose again so the self tapping screws could cut their own thread, same as the other three. Held up fine structurally, no cracking after screwing it in. Mounts acc...
This one needed the tightest tolerances since even a small shift throws off the camera calibration. Print came out flat and straight, no warping. Was worried the fit would be too loose and mess with c...
Rear right arm, has a motor at the end so it takes a good amount of torque and vibration, same as the other three. Needed good layer adhesion so it wouldn't crack at the base. No weak points after pri...
Front left arm, same deal as the others, motor at the end so it takes similar torque and vibration. Stiff enough for the sensors, still light. Holes accurate to the mm, made small on purpose so the se...
Central chassis for my deadcat drone frame with an onboard camera setup. Needed to be rigid so the camera mounts don't flex mid flight. Nylon PA12, accurate to the millimeter, honestly better than I e...
One of four arms on the drone. Needs to be stiff so vibration doesn't mess with the sensors but still light. PA12 handled that well. Holes were spot on to the mm, made them small on purpose so the sel...