Autonomous Deadcat Drone

One of four arms on the drone. Needs to be stiff so vibration doesn't mess with the sensors but still light. PA12 handled that well. Holes were spot on to the mm, made them small on purpose so the self tapping screws could cut their own thread going in, worked really well. Already been through a couple crashes and no cracking, held up better than I expected for a printed part.


Jul 10,2026
32 viewsReport item
PCB
HDI PCB
Assembly
FPC/
Rigid-Flex
X
Choose Num (pcs)
2 Layers
1.6mm
CNC
Machining
Sheet Metal
3D Printing
Injection
Molding
Aluminum
Aluminum
Resin
ABS
Engineer View Profile
6posts 0followers 0following
  • Comments(0)
  • Likes(0)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000

    You might like

    After building FPAA shields for the Arduino Uno and Raspberry PI, it was time to develop a version to interface with an ESP32. The ultimate goal is to create a platform that allows to connect differen...
    I had an excellent experience with this PCBWAY. I was genuinely amazed by the finished product. The quality far exceeded my expectations — the product is extremely well-made, very rigid, beautifully f...
    I had an excellent experience with this PCBWAY. I was genuinely amazed by the finished product. The quality far exceeded my expectations — the product is extremely well-made, very rigid, beautifully f...
    The PCB was of very good quality and the project was easily assembled with my own components,
    I had an excellent experience with this PCBWAY. I was genuinely amazed by the finished product. The quality far exceeded my expectations — the product is extremely well-made, very rigid, beautifully f...
    I had an excellent experience with this PCBWAY. I was genuinely amazed by the finished product. The quality far exceeded my expectations — the product is extremely well-made, very rigid, beautifully f...
    This was an amazing work! I have left my review as a post in my personal page + a LinkedIn post (see below). - In my website: https://jalopezg.dev/2026/07/09/PCBWay-p18clock-sponsorship/, which ...
    Back left arm. Holes made small on purpose again so the self tapping screws could cut their own thread, same as the other three. Held up fine structurally, no cracking after screwing it in. Mounts acc...
    SHOW ME MORE