Bottom
Top
Adriuno
The components that you need will be:
-ATMEGA328P x1
-16MHz cristal oscilator x1
- 22 pf capacitor x2
-0.1uf capacitor x1
-10uf Capacitor x2
-Power jack x1
-L7805 x1
-Push button x1
-10Kohm resistor x1
-220ohm resistor x1
-3mm LED
-5 pin connector x1
-6 pin connector x2
-8 pin connector x1
-4x2 pin connector x1
Once you add them all you can start connecting them like so, BE SURE THAT YOU NAME THE DIGNALS THE SAME
Like GND, VCC, A0, A1.. etc
This way you can make the schematic look like a block diagram, the connections will be there when you change the vew to PCB.
Adriuno
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(1)
- Likes(3)
More by Engineer
-
A Compact Charging Breakout Board For Waveshare ESP32-C3
368 3 4 -
AI-driven LoRa & LLM-enabled Kiosk & Food Delivery System
383 2 0 -
-
-
-
ESP32-C3 BLE Keyboard - Battery Powered with USB-C Charging
590 0 1 -
-
mammoth-3D SLM Voron Toolhead – Manual Drill & Tap Edition
617 0 1
