Reproduction of Poly88 computer (chassis, circuit boards, power supply). Currently I only have the two variants of lids and circuit boards that my models use, but I will have the remainder of the CAD in the future. The circuit boards and enclosures were made at PCBWay.

I included a BOM, but I'm fairly certain without some serious dedication to sourcing these oddball components this project will be hand-assembled. I was unable to find a board mount keyed 5 circuit molex 0.093" header to match the original exactly. I provided a link to some cable mount connectors that are equivalent and the intent is to have a small pigtail on the board coming off that spot for the transformer to plug into. To match the original design the board side connector pins should be all male except the pin closest to the edge of the board which is female. You can of course omit this connector and wire the transformer directly to the board or use your own preferred connector on a short pigtail.

Full project writeup starts here: https://abzman2k.wordpress.com/?p=4981